how to

super cool videos coming soon!
 
HOW TO APPLY YOUR STICKY MONKEY LABELS
There are 3 parts to your label. The 1st layer is the TRANSFER TAPE, it IS clear. The 2nd layer is the actual LABEL. The 3rd layer is the BACKING PAPER, its white. 

1. Clean your desired surface. Make sure it is completely dry. 

2. Cut off desired label. Cut through all three layers. Use the application tool to firmly rub the label, this will ensure the label is sticking to the application tape.

 4. Slowly peel away white backing. The label should be Sticking to the application tape. If it gives you trouble, give it a rub.

 5. Decide where you will place your label. Start at one end of the label and press down firmly as you work your way to the other end. This will ensure you do not get any air bubbles. If you are applying to a flat surface, Use the application tool firmly rub the label a few times. If you are applying to a cup or other curved surface, use your finger instead. Use some pressure to ensure the label is sticking, and there are no air bubbles.

 6. Starting at the top left corner, slowly peel away application tape. Pull it down at an angle on top of itself. If the label is not sticking to the surface, give it another rub. On some glossy surfaces you might need to hold down the first part of the label to get it started.

 7. If there are any air bubbles in your label, it is easy to fix. Get a small stick pin, and poke a tiny hole in the bubble. Gently rub your finger across the bubble to smooth it out.

 Label Care: Do not wash or use your labeled item for 24 hours. Time is needed to ensure a proper application. We do not advise putting your labels in the microwave, it will breakdown the adhesive thus shortening the life span of the label. Use a normal wash and dry cycle on your dishwasher. Follow these rules, and your labels should have a long happy life!
 
 

HOW TO APPLY DOTS, STARS AND OTHER GRAPHICS

Dust your wall surface with a dry cloth.  If they are really dirty, clean with a damp cloth and let dry for at least an hour.  Make sure the wall is clear of any dust or dirt.

Cut apart any graphics that may have come on a full sheet

Give your graphic a little rub with your application tool.   You must do this to make sure it is sticking to the clear transfer tape.

Remove white backing from the graphic.

Smooth graphic on to your surface.  If you have bigger graphics, start smoothing from the top down. Using this method will decrease the chance of getting any air bubbles.

Use the application tool to press graphic firmly in a side to side motion.  Try to make sure that air is not trapped under your graphic.

Now it is time for the big reveal! 
This is very important!  Pick a top corner and slowly peel the tape off at a 90 degree angle.  Peel the transfer tape down on top of itself.  Do not pull it toward you, pull it down! You do not want to just rip off the tape, this will cause air bubbles!